Belts Editor
In productionCurved-belt drawings, from the calculation sheet
Type the figures off a Kurvenbandberechnung sheet and get the cutting DXF: contour, hole rings, joint markings and measuring marks, on the layers the cutter expects. Splice angles, Z-joint teeth and ADV allowances are drawn the way the shop draws them, measured off its own reference belts rather than guessed.
Who it is for. Whoever turns a calculation sheet into a cutting file.
Download
v1.0.0Downloads are restricted. You will be asked for your e-mail address and sent a one-time code. How access works
What it does well
It reads its own drawings back
A saved DXF carries its parameters, so opening one puts every slider back where it was instead of guessing from the geometry.
Endless belts in pieces
A 360° loop cut into segments keeps one hole pitch the whole way round, and every joint lands halfway between two holes.
It refuses what it cannot cut
A hole across a measuring mark destroys the thing the mark is there to measure from, so it is refused rather than drawn.
English and Slovak
The whole interface, switchable without restarting.